SurfboarSkinz Installation Video

Before you begin make sure you remove ALL the wax from the surface.
Any wax residue left on the surface will cause the skin to fail.

I recommend a citrus cleaner after scraping the wax off.

Step 1. Align the printed stringer to the real stringer and tape in place.
Step 2. Repeat step one on the tail, make sure the nose does not move.
Step 3. Install a tape line across the deck of the board holding the skin in place.
Step 4. Pull skin away from the liner paper and lay flat with adhesive side up.
Step 5. Cut liner paper off with scissors.
Step 6. Run squeegee down the stringer then from stringer to rails to get all the air out.
Step 7. Remove tape across deck and tail.
Step 8. Fold skin over and remove liner paper, repeat step five.
Step 9. Don’t worry about air bubbles, be careful not get wrinkles.
Step 10. Squeegee out air bubbles and your done.